-96-
14. DESCRIPTION OF FUNCTION & CIRCUIT OF MICOM
- 96-
14. DESCRIPTION OF FUNCTION & CIRCUIT OF MICOM
14-1 FUNCTION
14-1-1 Function
1. When the appliance is plugged in, it is set to 37°F for Refrigerator and 0°F for freezer.
You can adjust the Refrigerator and the Freezer control temperature by pressing the ADJUST button.
2. When the power is initially applied or restored after a power failure, it is set to Control temperature Previously.
3.
14-1-2 How to Toggle the Display between °F & °C
1. The initial setting is °F and the display temperature mode can be changed from °F to °C or °C to °F by pressing and
holding the FRZ TEMP and the REF TEMP keys at the same time for over 5 seconds.
Top display is turned on when the door is left open.
14-1-3 Water Filter condition display fucntion
2. Water filter needs replacement every six months for using water filter.
3. When the Replace Icon blinks, you must exchange the filter.
4. After replacing the filter, press and hold the water filter reset button for 3 seconds.
After then water Filter icon turn off with reset status.
1.. There is a replacement indicator light for the water filtter cartridge.
14-1-4 Ice Plus selection
When you press and Ice Plus button, the Ice Plus ICON will be turned on again.
Ice Plus function automatically turns off after a fixed time passes.
2.
1.
This function increases both ice making and freezing capabilities.
3.
14-1-7 How to set the display mode and cancel it
1. With the refrigerator door open, keep pressing the Refrigerator Temp Button and Ice Plus Button more than
5 seconds, then it goes to the display mode with Special Beep Sound With Special Beep Sound.
2. Perform the same way again to cancel the display mode.
3. All Freezing unit will be turned off at display mode (Exceptions : Lamp, Display)
14-1-5 Control of Freezer fan motor
1. Freezer fan motor has high and standard speed.
2. When refrigerator is overloaded, fan motor runs in high speed as powered-up Standard speeds is used for general
purposes.
3. To improve cooling speed, the RPM of freezer fan motor changs from normal speed to high.
14-1-6 Cooling Fan Motor
1. The cooling fan is switched ON and OFF in conjunction with the compressor.
2. The Failure sensing method is the same as in the fan motor of the freezing fan motor(refer to failure diagnosis function
table for failure display).
To Next Page
