LG LMV1852ST User Manual

– 5 –
Parts, Tools, Materials
Clear Tape
(for taping the templates to the wall)
Phillips Screwdriver
(for the screws)
Flat Blade Screwdriver
(for the toggle bolts)
Plumb Line
Measuring Tape
(metal preferred)
Duct Tape
Caulking Gun and Caulk
Stud Finder or Thin Nail
Saber Saw
(for cutting vent holes for roof
or wall venting)
Keyhole Saw (for the power cord hole)
You will need the following tools and materials for the installation:
Carton or other heavy material such as a blanket for covering the counter top.
3/8" and 3/4" wood drill bits
1/2" and 3/16"
drill bits
Electric Drill
Small Side Cutters(Nipper) or Tin Snips
If you have brick or masonry walls, you will need special hardware and tools.
The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper.
(Shown on page 4).
Wear proper gloves to protect your hands from injury.
Gloves
Pencil

LG LMV1852ST Specifications

General

Turntable	Yes
Control type	Touch
Product color	Stainless steel
Microwave power	- W
Appliance placement	Countertop
Number of power levels	10
Connected load	1000 W

Weight and Dimensions

Depth	381 mm
Width	736.6 mm
Height	406 mm
Weight	22000 g