ttOWlO USE
USING THE CONTROLS
AUTO CLEAN
To turn the AUTOCLEANfunction on, press the
AUTOCLEANbutton while the air conditioner is
c_+_ SAVER mode. This function
can only be selected from the
remote ;it is not available from
the control panet.lt must be set
each time you wish to run the AUTOCLEAN
function.
AUTOCLEAN is used to remove moisture from
the heat exchange coils. This helps prevent the
formation of mildew and odors.
ATo use AUTO CLEAN
With the air conditioner running in COOL,
DRY or ENERGYSAVER mode, press the
AUTO CLEAN button.
• Jb "AUTO CLEAN" will be displayed in the
LCD diplay.
Press the POWER button to turn the air
cond itioner off.AUTO CLEANwill run
the circulation and exhaust fans with the
compressor off for a few minutes after
the power is turned off.
To cancel AUTOCLEAN, or to stop an
AUTOCLEANcycle in process, simply press
the AUTO CLEANbutton again. The AUTOCLEAN
function will not operate if the air conditioner is
already off.
AUTO SW/NG
AUTOSWING function can only be activated with
the remote. When this function is on, the air
Auto
Swing
remote again.
discharge will oscillate to
circulate air more evenly
through the room. To turn this
function off, simply press the
AUTOSWING button with the
With AUTOSWING off, you may also manually
adjust the air discharge to the desired position.
It will maintain this position until the air
cond itioner is turned off or AUTOSWING
is activated.
oC =*F
°C=°F function can only be activated with the
oc=oF remote.When the displayed
temperature is °C(of °F),you
can press this button to swith
to °F(or °C).
To Next Page
Loading...
Need help?
General
