PARlS AND FEAlURES
CONTROLPANEL AND REMOTE
A PART
I
B PART
NOTE:Please press the _ part to operate the button.
Operation of functions is the same when using the remote or the
control panel, unless otherwise stated.
For detailed instructions on each function, see the following pages
POWER ON/OFF
Turns the air conditioner on and off. When turning on,
a rising tone will sound to confirm. When turning off,
a descending tone will sound.
AUTO CLEAN
The AUTO CLEAN function is used to remove
moisture from the heat exchangers and helps
prevent odor from forming. This function can be
activated from the Remote only.
FAN
Adjusts the circulation fan speed between low (F1),
medium (F2), and high (F3}
MODE
Switches the air conditioner between COOL, FAN,DRY,
and ENERGY SAVER modes. The active mode will be
shown in the LCD display.
LCD DISPLAY
A PART shows the set temperature ( °Cor °{2),
fan speed, or the selected TIMER delay.
B PART shows the active mode(COOL,FAN,DRY and
ENERGY SAVER),Auto clean,Water full and Timer.
,L / Y (TEMP/T/MER)
Use these buttons to adjust the set temperature up or
down, or to adjust the timer delay time.
TIMER
Allows you to set a delay from 1 to 24 hours that will
turn the air conditioner on or off automatical ly.
oC_OF
C001 Fan Dry
Tirl:er .,dill
!211--1.,
Et lZto_
Auto Auto Energy
Clean Swing Saver
Use this button,the temperature display can be switched
between degrees Celsius(°C) and degrees Fahrenheit(°F ")
AUTO SWING
Sets the motorized air discharge to oscillate,
improving air circulation in the room. This function
can only be activated and displayed from the remote
control.
To Next Page
Loading...
Need help?
General
