40
CARE AND CLEANING
Removing the Drawer
Disconnect the electrical power to the range at
the main fuse or circuit breaker panel. Failure to
do so can result in severe personal injury, death, or
electrical shock.
WARNING
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further cleaning
is needed. Use warm water to thoroughly clean.
1. Fully open the drawer.
2. Remove the two screws.
Remove screws
3. Locate the glide lever on each side of the drawer.
Push down on the left glide lever and pull up on the
right glide lever.
Lever
Push down with nger
Pull up with nger
Lever
4. Pull the warming drawer away from the range.
Replacing the Drawer
1. Pull the bearing glides to the front of the chassis
glide.
2. Align the glide on each side of the drawer with the
glide slots on the range.
3. Push the drawer into the range until levers “click ”
(approximately 2 inch).
4. Pull the drawer open again to seat bearing glides
into position.
5. Replace the two screws.
To Next Page
Loading...
Need help?
General
