2-2. Dispenser use selection
You can select water or ice.
❉ Select WATER, CRUSHED ICE, or CUBED ICE by pressing the button as
you desire.
❉ Use your cup to press lightly on the actuator.
• Each graphic is indicated for the selected function.
• You’ll hear a CLICK when the ice door closes 5 seconds after ice is dispensed.
REFERENCE : Hold your cup in the dispenser for a few seconds after dispensing
ice or water to catch the last few drops or pieces of ice.
2-3. ICE PLUS Freezing/JET Freezing Selection
Select this function to expedite freezing.
• Press the button to cycle to toggle between the settings.
• The arrow mark graphic remains at the ON status after flickering 4 times when selecting Special Refrigeration ICE PLUS
FRZ or JET FRZ.
• ICE PLUS freezer or JET freezer function automatically turns off after a set time.
• Jet Freezing : Not applicable to all models.
2-4. Dispenser Light
• The dispenser light function is repeated following below whenever pressing LIGHT/FILTER button.
• Auto mode is automatic control of the dispender light by using the light sensor.
MICOM FUNCTION
- 15 -
LED (GR-L277SV(S)VA)
(LSC27950SW, LSC27950SB, LSC27950ST)
LCD (GR-L277SSWA) (LSC27960ST)
ON ON OFF
LED (GR-L277SV(S)VA) LCD (GR-L277SSWA)
(LSC27960ST)
(LSC27950SW, LSC27950SB, LSC27950ST)
To Next Page
Loading...
Need help?
General
