2-5. ICE PLUS freezing
1. ICE PLUS freezing is a function to increase the cooling speed of the freezer compartment by running both the
compressor and the fan simultaneously.
2. ICE PLUS is cancelled and the refrigerator returns to its default setting in the event of a power interruption.
3. Selecting ICE PLUS changes only the speed of the cooling without affecting the set temperature.
4. The temperature can be adjusted even when ICE PLUS has been selected and is in progress.
5. The freezer operates at whatever temperature was set at the time ICE PLUS was selected.
6. If you select ICE PLUS, the compressor and fan will run until it is deselected or the cycle time has elapsed.
(3 hours : compressor and fan run / 3 ~ 24 hours : COLDEST operation)
7. If a defrost cycle occurs while an ICE PLUS is already running, ICE PLUS runs for its remaining cycle time after the
defrost cycle is completed. If the defrost cycle takes longer than 30 minutes, ICE PLUS will run for only 2 hours at the end
of the defrost cycle.
8. If you press ICE PLUS during a defrost cycle, the ICE PLUS indicator (LCD or LED, depending upon the model) will
illuminate but the compressor will not operate until the defrost cycle is complete.
9. If you press ICE PLUS within 7 minutes of compressor cut-off, the compressor will not operate until the 7-minute delay
has passed.
10. The freezer fan motor runs at high speed during the ICE PLUS cycle.
2-6. JET FREEZING (GR-L277SSWA / LSC27960ST)
1. JET FREEZING is a function to increase the cooling speed of the JET FREEZING compartment within the freezer by
running both the compressor and the JET FREEZING fan simultaneously.
2. JET FREEZING is cancelled and the refrigerator returns to its default setting in the event of a power interruption.
3. The display temperature is not changed by selecting JET FREEZING.
4. If JET FREEZING is selected, the compressor (after the 7-minute compressor delay time passes) and the freezer fan
motor will operate. The temperature in the refrigerator will drop and the fan motor will be off while the JET FREEZING
cycle runs, a maximum of 2 hours. The JET FREEZING indicator will go off at the end of the JET FREEZE cycle.
5. To prevent icing up, the JET FREEZING fan motor will cycle for 10 seconds every hour when JET FREEZING is not
selected.
6. If the JET FREEZING fan motor fails, this failure will not be detected because it is a 12-volt DC operation.
7. To check the JET FREEZING function, press and hold the FREEZER button or ICE PLUS/JET button for more than one
second. The JET FREEZE fan will operate.
MICOM FUNCTION
- 16 -
To Next Page
Loading...
Need help?
General
