LG LW6023R - Chassis Preparation and Window Fit

12
EN
Preparation of Chassis
1
Align holes between the upper guide and the
top of the cabinet and then install it with 3 type
A screws.
Upper GuideUpper Guide
Screws (Type A)Screws (Type A)
NOTE
• The feature may be changed according to the
type of model.
2
Insert the top and bottom rails of the curtain
panels into the upper and lower panel guides
Fasten the curtain panels to the unit with
8 type A screws Fasten screws behind the
curtain panel.
Right Right
Curtain Curtain
PanelPanel
Left Left
Curtain Curtain
PanelPanel
Right Curtain PanelRight Curtain Panel
Left Curtain PanelLeft Curtain Panel
Screws Screws
(Type A)(Type A)
CurtainCurtain
Screws Screws
(Type A)(Type A)
Bottom GuideBottom Guide
NOTE
• Use a long screwdriver to make installing the
screws easier.
• The feature may be changed according to the
type of model.
3
Cut the window sash seals (Foam-PE) to the
proper length. Peel off the backing and attach
the adhesive-backed foam to the underside
of the window sash and the bottom of the
window frame.
Foam-PE Foam-PE
(Adhesive backed)(Adhesive backed)
4
Open the window and draw a center line on
the center of the inner sill. Then mark lines
7.5” to the left and right of the center line.
7.5"
7.5"
Inner SillInner Sill
Center LineCenter Line
Room SideRoom Side
5
Install the L bracket behind the inner window
sill, as shown. Use the 2 type A screws
provided.
7.5
7.5
Screws Screws
(Type A)(Type A)
Inner SillInner Sill
Center LineCenter Line
Outer SillOuter Sill
L BracketL Bracket
NOTE
• The bracket helps to hold unit securely in place.
Be sure to place bracket edge flush against
back of inner sill.
•