EXTERNALEQUIPMENT SETUP
Auto Configure (RGB [PC] mode only)
Automatically adjusts picture position and minimizes image instability. After adjustment, if the image is still
not correct, your set is functioning properly but needs further adjustment.
Auto configure
This function is for automatic adjustment of the screen position, clock, and phase The displayed image will
be unstable for a few seconds while the auto configuration is in progress.
1. Using OSD
Select PICTURE.
Select SCREEN.
• If the position of the image is still not correct,
try Auto adjustment again.
• If picture needs to be adjusted again after Auto
adjustment in RGB (PC), you can adjust the
Position, Size or Phase.
Select Auto Config.
Select Yes.
Run Auto Config.
• Press the MENU or EXIT button to close the menu window.
• Press the BACK button to move to the previous menu screen.
26
To Next Page
Loading...
