APPENDIX
TROUBLESHOOTING
Check to see if there is any object between the product and the remote control caus-
ing obstruction. Ensure you are pointing the remote control directly at the set.
Ensure that the batteries are installed with correct polarity (+ to +, - to -).
Install new batteries.
______________________________________________________________________________________________________________________________________________________________
______________________________________________________________________________________________________________________________________________________________
______________________________________________________________________________________________________________________________________________________________
_____________________________________________________________________________________________________________________________________________________________
_____________________________________________________________________________________________________________________________________________________________
Check whether the product is turned on.
Try another channel. The problem may be with the broadcast.
Is the power cord inserted into wall power outlet?
_1_Check your antenna direction and/or location.
Test the wall power outlet, plug another product's power cord into the outlet
where the product's power cord was plugged in.
This is normal, the image is muted during the product startup process. Please
contact your service centre, if the picture has not appeared after five minutes.
Adjust Colour in menu option.
Keep a sufficient distance between the product and the VCR.
Try another channel. The problem may be with the broadcast.
Are the video cables installed properly?
_l_Activate any function to restore the brightness of the picture.
Check for local interference such as an electrical appliance or power tool.
Station or cable product experiencing problems, tune to another station.
Station signal is weak, reorient antenna to receive weaker station.
Check for sources of possible interference.
[Jl_Check antenna (Change the direction of the antenna).
84