• The Display Luminosity of the unit can be adjusted by using the
Remote Controller.
Press the start/stop button to start the unit. Open the door on the
Remote Controller, press the 2
nd
F button and, press display luminosity
button. Display will be dark. Press the button again to set bright display.
1. Press the Start/Stop button to Start the unit.
2. Open the door on the Remote Controller
Select Cooling Operation or Healthy Dehumidification Operation.
3. Press the Auto clean button.
4. Although the Start/Stop button is pressed, unit operates in Auto clean Mode for 15
minutes - operates in heating operation Mode for 1 minute and circulates the room
air without cooling and heating for 14 minutes. And then unit stops operating.
NOTE:
❏ During Auto Clean function, moistures left in indoor units after Cooling Operation or Healthy
Dehumidification Operation can be removed.
❏ During Auto Clean function, only Start/Stop button, Plasma button and Auto Clean button are available.
Auto Clean (Artcool, Artcool Deluxe Type Only)
Display Luminosity (Artcool Deluxe Type Only)
Circulates the room air without cooling or heating.
1. Press the Start/Stop button. The unit will respond with beep sound.
2. Open the door on the Remote Controller. Press the Air Circulation button. Now each time that you
press the Indoor Fan Speed Selector, the fan speed is shifted from low to CHAOS and back to low
again.
❏ CHAOS Air economizes power consumption and prevents overcooling. The fan speed is automatically
changed from high to low or vice versa, depending on the ambient temperature.
To Next Page
Loading...
Need help?
General
