Radio Operations
Be sure that both FM and AM aerials are
connected. (Refer to the page 19)
Listening to the radio
1. Press RADIO&INPUT until FM or AM (MW)
appears in the display window.
The last received station is tuned in.
2. Press and hold TUNING (-/+) for about
two seconds until the frequency indication
starts to change, then release. Scanning
stops when the Unit tunes in a station.
or
Press
TUNING (-/+) repeatedly.
3. Adjust the volume by rotating MASTER
VOLUME on the unit or by pressing VOL
(+/ - ) on the remote control repeatedly.
Presetting the Radio Stations
You can preset 50 stations for FM and AM
(MW).
Before tuning, make sure that you have turned
down the volume.
1. Press RADIO&INPUT on the remote control
or RADIO on the unit until FM or AM (MW)
appears in the display window.
2. Press or rotate to select a desired frequency;
- On the remote control: TUNING (-/+)
- On the unit:
MULITI JOG DIAL or
.
/
>
3. Press ENTER a preset number will ash in
the display window.
4. Press PRESET (-/+) to select the preset
number you want.
5. Press ENTER.
The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. Press to select a preset station;
- On the remote control:
PRESET -/+ or
0 to 9 numerical buttons
- On the unit:
n
PRESET - / PRESET +
N
Deleting a saved station
1. Press PRESET - / + to Select a preset
number you want to delete.
2. Press CLEAR, the preset number will blink
in the display window.
3. Press CLEAR again, to delete the selected
preset number.
Deleting all the saved stations
1. Press and hold CLEAR for two seconds.
"ERASE ALL" will ash up on the unit display.
2. Press ENTER or CLEAR to erase all saved of
the radio stations.
Improving poor FM reception
Press PLAY (MONO/STEREO) on the remote
control. This will change the tuner from stereo
to mono and usually improve the reception.
To Next Page
Loading...
Need help?
General
