7
EN
• Ensure the appliance is installed level. Otherwise, it may cause vibration
or water leakage.
• Make sure that the base of the outdoor unit is firmly fixed.
• Install the drain hose properly for the smooth drainage of water
condensation.
• Do not insert a drain hose in drain or soil pipe. Bad smells can occur and
it results in a corrosion of a heat exchanger or pipe.
• Do not touch the leaking refrigerant during installation or repair.
• Always check for gas (refrigerant) leakage after installation or repair of
appliance.
• Be cautious not to get injured by the sharp edges while installing the
appliance or taking it out of its packaging.
• Ensure that you carry by the chassis when you lift the unit.
• This appliance should only be transported by two or more people holding
the appliance securely.
• During working on heights fasten safety belt to put for personal safety.
• Safely dispose of packing materials such as screws, nails, plastic bag or
batteries using proper packaging after installation or repair.
• To avoid nitrogen entering the refrigerant system in a liquid state, the top
of the cylinder must be higher than its bottom when you pressurize the
system.
• Do not use the appliance for special purposes, such as preserving foods,
works of art, and etc. It is an appliance for consumer purposes, not a
precision refrigerant system. There is risk of damage or loss of property.
To Next Page
Loading...
