Connecting 19
Use A / V / <_ / _ to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
_- @ Note
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using A/V /
_/)' and numerical buttons. If:you make a
mistake while entering a number, press CLEAR
to clear the highlighted part.
3. Select [Next] and press ENTER (®) to apply
network settings.
4.
Network connection status is displayed on the
screen.
Press ENTER (®) while [OK] is highlighted to
finish the wired network settings.
Wireless network connection
Another connection option is to use an Access Point
or a wireless router.The network configuration and
connection method may vary depending on the
equipment in use and the network environment.
Communication
DLNA certified servers
Access Point or
Wireless Router
Ref:erto the setup instructions supplied with
your access point or wireless router for detailed
connection steps and network settings.
For best performance, a direct wired connection
from this unit to your home network's router or
cable/DSL modem is always the best option.
If:you choose to use the wireless option, please
note that perf:ormance can sometimes be affected
by other electronic devices in the home.
©
o
To Next Page
Loading...
