LG NB3740 - Wireless Network Connection

20 Connecting
Wireless network setup
For the wireless network connection, the unit needs
to be set up f:or network communication.This
adjustment can be done f:rom the [Settings] menu.
Adjust the [NETWORK] setting as f:ollow. Setting up
the access point or the wireless router is required
bef:ore connecting the unit to the network.
f-
Preparation
Bef:ore setting the wireless network, you need
to:
- connect the broadband internet to the
wireless home network.
- set the access point or wireless router.
- note the SSID and security code of:the
network.
. Select [Connection Setting] option in the
[Settings] menu then press ENTER (®).
2. Read the preparations f:or the network settings
and then press ENTER (®) while [Start] is
highlighted.
3.
If:wired network is not connected to the unit, all
available networks are displayed on the screen.
Use A/V to select a desired SSID of:wireless
network and press ENTER (®).
If:you have security on your access point, you
need to input the security code as necessary.
_ O Note
If:you use other characters than the english
alphabet or digits f:or the SSID name of:your
access point or wireless router, it may be
displayed differently.
.- @ Note
• WEP security mode generally have 4 keys
available on an access point setting. If:your
access point or wireless router use WEP
security, enter the security code of:the key
"No.1 "to connect on your home network.
An Access Point is a device that allows you
to connect to your home network wirelessly.
4. Use A/V / </> to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
..... @ Note
If:there is no DHCP server on the network and
you want to set the EPaddress manually, select
[Static] then set [EPAddress], [Subnet Mask],
[Gateway] and [DNS Server] using A/V/
</> and numerical buttons. El:you make a
mistake while entering a number, press CLEAR
to clear the highlighted part.
5. Select [Next] and press ENTER(®) to apply
network settings.
Network connection status is displayed on the
screen.
Select [OK] and press ENTER (®) to complete
the network connection.