FILTER CLEANING AND EXCHANGE
27
ENGLISH
Cleaning method of tray and humidifier filter
Classification
Replacement
cycle
Cleaning
cycle
Cleaning method
Water tank - Daily
• When filling the water tank, fill up to 1/3
and rinse it 4-5 times to wash it out.
• Dissolve 10g of neutral detergent or citric
acid in 1L of warm water for 1-2 hours, and
then use the cleaning brush to clean the
parts. After cleaning, make sure to rinse
sufficiently. (After cleaning the filter, close
the front panel. If not closed completely, the
product will not work.)
• Make sure to clean with a soft brush any
white powder contents, around the filter or
the case, which may cause a smell or noise.
Tray - Daily
Humidifier
filter
6-12
months
More
than
1 time
weekly
• Rinse the water
tank by shaking 4-
5 times.
2. Insert the float
hook into the hole.
* Citric acid: Can be purchased at pharmacy or on the Internet.
• Frequently wash the tray and humidifier filter. This will remove
the scaling and you can use the product better sanitary condi-
tion.
• Do not disassemble the float of the tray. It can cause product
failure. If the product is disassembled by impact, assemble in
the order show in the right picture.
• Do not take the humidifier filter case apart. This may result in
deformation or damage in the filter or the case.
• In cleaning, wipe the filter gently with a brush, or the fiber can
be degraded.
• After cleaning
with neutral deter-
gent or citric acid,
rinse the filter
with clean water.
• When washing the
humidifier filter
case, be careful as
it can be damaged.
• Wipe softly the
humidifier filter
with a brush, by
holding the case.
CAUTION
• If the part is not rinsed sufficiently it can carry the odor of the detergent or citric
acid, and can cause discoloration or deformation of the product.
• White chunk can be attached on the humidifier filter or the filter can be discol-
ored to red or yellow during use. This is due to the impurity such as calcium in-
cluded the tap water and is a normal phenomenon.
!
1. Insert the float
under this hook.
3. Insert the hook on
the other side of the
float to the hole.
To Next Page
Loading...
