y
The rst time it takes 25 seconds (and may
take longer) for the speaker and the woofer
station to communicate with each other and
make sounds. (Reconnecting : 15 seconds)
y
Once connecting is performed, it does not
need to be done again even if you turn off
this unit.
y
In Dual Play mode, the connection the woofer
station and the speaker is not supported.
(Page 23)
- Check that speaker is Dual play mode by
verifying that Dual Play LED turns on.
- Press
button for 2 seconds to cancel
Dual Play mode. And then you must place
the speaker on woofer station for being
able to connect speaker and woofer
station.
y
Even if woofer station and speaker are
separated, connection is maintained.
y
If the speaker is too far from the woofer
station, the sound quality may be lowered.
y
Avoid the cases below.
- There is a device using same frequency
with this wireless connection such as
a medical equipment, a microwave or a
wireless LAN device.
- Keep the speaker and the woofer station
away more than 1 m from the device (ex.
wireless router, microwave oven, etc.) to
prevent wireless interference.
!P
,
Note
To Next Page
Loading...
