3.1.2 Function Description
Category Level1 Level2 Level3 DESCRIPTION
Basic function
Temp setting - -
Operation mode
Cooling -
Cool the room to the desired temperature.
- Setting range : 18~30 ℃
Heating -
Heats the room the desired temperature.
- Setting range : 16~30 ℃
Dehumidification - It removes the moisture with cooling.
Fan - Fan only operation, no cooling or heating.
AI or Auto changeover
AI for C/O
Auto Changeover for H/P
The product automatically provides the appropriate fan speed based on the
temperature of the room
Power cooling - It provides strong cooling in short time.
Power heating - It increases indoor temperature quickly.
Display indoor temperature
- - It display indoor temperature.
Fan Speed
Slow -
It is a function to set the Fan speed of the indoor unit.
* For chaos, fan speed is displayed repeatedly
[Low → Medium → High → Low…].
Low - -
Medium - -
High - -
Chaos - -
Wind direction
Up/Down swing - The vane moves up and down repeatedly.
Left/Right swing - The vane moves left and right repeatedly.
Up/Down airflow direction - You can set the upper and lower angle of the vane to the desired position.
Left/Right airflow direction - You can set the left and right angle of the vane to the desired position.
Direct wind - It operate at the maximum angle. It is suitable for high ceiling.
Indirect wind -
It operate at the minimum angle. Provides air flow that blows away from user
for comfort.
Smart mode -
Smartly keeps set temperature by adjusting the wind direction automatically.
Refresh mode -
Adjust the temperature of the direct and indirect wind to create a comfortable and
efficiency working environment.
Sub function /
Function setting
Air Purify - -
It makes the indoor air clean and pleasant.
Air purify alone operation can be used only for dust sensor applied products.
Dust lamp always display
(Smart indicator)
--
It is a function to set to always display the status of fine dust on the display of
products equipped with a dust sensor.
Setting for brightness of
IDU display
- - It is a function to control the brightness of the LED of the product's display.
Auto drying (Auto clean) - -
When the product is off after cooling operation, it is the function to dry the
inside of the indoor unit to remove mold and moisture.
Energy saving cooling - -
This is a function that improves the user's comfort and power saving performance
by raising the desired temperature after an appropriate time elapses after the
indoor temperature reaches the desired temperature during cooling operation.
Robot cleaning
(Smart clean)
--
Robot cleaning function is the function to automatically perform the filter clean-
ing with the cleaner in the product when the air conditioner is used for certain
period of time.
Electric Heater - -
It is the function to reinforce the heating capability by turning on the electric
heater during the heating operation.
Comfort cooling - -
The comfort cooling is the function to automatically control the cooling strength
to maintain the pleasant feeling without turning off the product after the indoor
temperature reached the desired temperature.
Setting /checking address
of central controller
--
When multiple indoor units are controlled by the central controller, you can set
and confirm a number to distinguish each indoor unit.
Setting the change tem-
perature for auto
changeover
--
This function sets the range of the cooling / heating switching temperature of
Auto Changeover mode.
Celsius/Fahrenheit
Switching
- - This function sets the temperature unit displayed on the remote controller.
To Next Page
Loading...
Need help?
General
