LG PW1000 - Page 10

10
SAFETYINSTRUCTIONS
CAUTION
• Contact your seller or our
service center once a year to
clean the internal parts of the
projector.
- If you do not clean the
projector for a long period of
time, dust will accumulate,
which may result in re or
damage to the projector.
• When cleaning plastic parts
such as the projector case,
unplug the power first and wipe
with a soft cloth. Do not spray
with water or wipe with a wet
cloth. Never use glass cleaner,
automobile or industrial polish,
abrasives, wax, benzene, or
alcohol as these can damage
the projector.
- This can result in re, electric
shock, or cause damage to
the product (deformation and
corrosion).
• Remove the plug from the outlet
before cleaning the product.
- Otherwise, this may result in
electric shock.
Others
WARNING
• Some users may experience
a seizure or other abnormal
symptoms when they are
exposed to a flashing light or
particular patterns from a video
game.
• When you go out, place the
projector out of reach of
animals, and remove the power
plug from the wall outlet.
- Using a damaged power cord
may result in short circuit
or re.
• Do not use the projector near
high-precision electronic devices
or those that transmit weak
radio signal.
- This may affect the operation
of the product, causing an
accident.
• Only a qualified technician
can disassemble or modify
the projector. For diagnosis,
adjustment, or repair, contact
your seller or our service center.
- This may result in re or
electric shock.
• Proper ventilation required, do
not block airflow around unit.
Doing so can cause injury and
internal overheating.
• To prevent damage to lamp,
unit must remain plugged in for
approximately 3 minutes after
power down to allow for proper
cool down (not applicable on
LED models).