1-5
1. Press (POWER).
The initial setup wizard appears on the screen.
2. Use /// to select a display language and
press ENTER ().
3. After checking the Terms of Service, select
[Agree] to use the Premium Service and SW
Updates. Read and prepare the preparations for
the network settings and then press ENTER ()
while [Start] is highlighted.
If wired network is connected, the network
connection setting will automatically be fi nished.
4. Select [Next] and press ENTER ().
5. Press ENTER () to verify the test tone signals of
the speakers.
After verifying the test tone signals, press ENTER
() while [Stop] is highlighted.
Select [Next] and press ENTER ().
6. You can listen to TV sound through HTS
Speaker automatically when TV is turned on.
Press to move and press / to select [On]
or [Off]. Select [Next] and press ENTER ().
7. Check all the settings that you have set in the
previous steps.
Press ENTER () while [Finish] is highlighted to
fi nish the initial setup settings. If there is any
settings to be changed, use /// to select
and press ENTER ().
INITIAL SYSTEM SETUP
When you turn on the unit for the fi rst time, the initial setup wizard appears on the screen. Set the display language
and network settings on the initial setup wizard.
1
To Next Page
Loading...
Need help?
General
