Wireless subwoofer
connection
LED indicator of wireless subwoofer
LED Color Status
Green
(Blink)
Attempting to make
connection.
Green The connection is completed.
Red The wireless subwoofer
is in standby mode or the
connection is failed.
Off (No display) The power cord of wireless
subwoofer is disconnected.
Setting up the wireless subwoofer for
the first time
1. Connect the power cord to the wireless
subwoofer and plug the power cord into a power
outlet.
2. Turn on the main unit : The sound bar and wireless
subwoofer will be automatically connected.
- Green LED on the rear of wireless subwoofer
turns on.
Manually pairing wireless subwoofer
When your connection is not completed, you can
check red LED on the wireless subwoofer and the
wireless subwoofer does not make sound. To solve
the problem, follow the steps below.
1. Press Pairing button on the rear of the wireless
subwoofer.
- The green LED on the rear of the wireless
subwoofer blinks quickly.
2. Turn on the main unit.
3. Pairing is completed.
- The green LED on the rear of the wireless
subwoofer turns on.
y
It takes a few seconds (and may take longer)
for the main unit and the subwoofer to
communicate with each other and make
sounds.
y
The closer the main unit and the wireless
subwoofer, the better sound quality. It is
recommended to install the main unit and the
wireless subwoofer as close as possible and
avoid the cases below.
- There is an obstacle between the main
unit and the wireless subwoofer.
- There is a device using same frequency
with this wireless connection such as
a medical equipment, a microwave or a
wireless LAN device.
- Keep the sound bar and the wireless
subwoofer away from the device (ex.
wireless router, microwave oven, etc.)
over 1 m (3 feet) to prevent wireless
interference.
!P
IHHW
,
Note
To Next Page
Loading...
Need help?
General
Weight and Dimensions
