Manually pairing wireless receiver
When your connection is not completed, you can
see the red LED on the wireless receiver and rear
speakers are not made sound. To solve the problem,
follow the below steps.
1. Press PAIRING button on the rear of the wireless
receiver.
- The yellow - green LED on the wireless receiver
blinks quickly.
2. Turn on the main unit
3. Paring is completed.
- The yellow - green LED on the wireless receiver
turns on.
Surround sound
You can enjoy magnificent surround sound for all the
input sound source with rear speakers.
To turn on surround function, press and hold AUTO
VOL on the remote control for about 2 seconds
and press it once again while “OFF - SURROUND” is
scrolled.
To turn off surround function, press and hold AUTO
VOL on the remote control for about 2 seconds
and press it once again while “ON - SURROUND” is
scrolled.
When you input 2 channel sound sources (Music
or TV), this sound bar output as original sound
channel in the ASC and STANDARD sound
effect modes.
,
Note
To Next Page
Loading...
