LG SPM2 - Page 20

2-9
Copyright © 2022 LG Electronics Inc. All rights reserved.
Only for training and service purposes.
HOW TO ASSEMBLE THE BOTTOM HOUSING
Step 1
Step 2
Step 3
Step 4
Step 1
1-7. ASSEMBLE OF CORD WIRE (L Side)
Step 1. Assemble the speaker terminal. Step 2. Insert the speaker line in the groove.
Step 3. Connect the speaker(Sub woofer). Step 4. Please arrange the line along the red line.
Step 1
Step 2
Step 4
1-8. ASSEMBLE OF SMPS AND AC INLET JACK
Step 1. Assemble Red points Screw(CTB3+8GFZR) : 5 EA [Closing torque : 5.0 ± 0.5kgf.cm]
Step 2. Connect the Main PCB wire.
Step 3. Assemble Red points Screw(CTB3+8GFZR) : 2 EA [Closing torque : 5.0 ± 0.5kgf.cm]
Step 4. Connect the power line (red point). and insert the line into the groove. (Yellow point)