30
EN
Using Washer Cycle
Fernstart (Remote Start)
Use a smart phone to control your appliance
remotely. You can also monitor your cycle
operation so you know how much time is left in
the cycle.
To Use Remote Start:
1
Press the Power button.
2
Put the laundry in drum.
3
Press and hold Remote Start button for 3
seconds to enable Remote Start function.
4
Start a cycle from the LG Smart ThinQ
application on your smart phone.
NOTE
• Once the Remote Start mode is enabled, you
can start a cycle from the LG Smart ThinQ
smartphone application. If the cycle is not
started, the machine will wait to start the cycle
until it is turned off remotely from the
application or the Remote Start mode is
disabled.
• When Remote Start is turned on, the door is
automatically locked.
To Disable Remote Start:
When the Remote Start is activated, press and
hold Remote Start button for 3 seconds.
Download/Neu (Download Cycle)
Download new and special cycles that are not
included in the basic cycles on the appliance.
Appliances that have been successfully
registered can download a variety of specialty
cycles specific to the appliance.
Only one cycle can be stored on the appliance
at a time.
Once cycle download is completed in the
appliance, the product keeps the downloaded
cycle until a new cycle is downloaded.
Wireless LAN Module Specifications
Model LCW-004
Frequency
Range
2412 to 2472 MHz
Output
Power(Max)
IEEE 802.11b:17.82 dBm
IEEE 802.11g:17.72 dBm
IEEE 802.11n:16.61 dBm
Wireless function S/W version : V 1.0
For consideration of the user, this device should
be installed and operated with a minimum
distance of 20 cm between the device and the
body.
Standby power consumption 0.5 W
Network standby power
consumption
3.0 W
The period of time after which
the power management
function, or a similar function,
switches the equipment
automatically into standby and/
or off mode and/or the
condition providing networked
standby
20 min.
To Next Page
Loading...
