37
PROGRAMMING MODE
14. Time to keep the coin (Use only for coin type)
Entering set up
mode.
You will see LqC1
Button Display
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Display previous value.
Press Med Temp.(+) or Low Temp.(-) button to select time
between 0 ~ 180.
Press the Start button.
The machine sets up the time to keep the coin, then advances to
the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/o toggle switch
• Card type - Pull the service card
• OPL/Coin type – Press “High Temp.” twice
Time to keep the coin is available only in coin type. (It hasn’t affected on the card type’s time setting)
NOTE
MFL67863709_en_170328.indd 37 2017-03-28 �� 9:54:33
To Next Page
Loading...
Need help?
General
