<< 17
Getting Started
3. Slide the SmartChip into the SmartChip socket. Make sure that the
SmartChip is inserted properly and that the gold contact area on the card
is facing downwards. To remove the SmartChip, press down lightly and pull
it in the reverse direction.
n Note
When you need to remove the SmartChip, slide it, as shown, and take it out of the
socket.
4. To insert the battery, align the golden contacts of the battery with the
corresponding connectors on the battery compartment. Press down on the
opposite end of the battery until it snaps into place.
5. Attach back cover by sliding it up into position until it clicks.
To Next Page
Loading...
