12
EN
SELECTING THE INSTALLATION PLACE
Indoor Unit
• Install the indoor unit on a strong wall that is not
subject to vibrations.
• The in let and outlet ports should not be
obstructed: the air should be able to blow all over
the room.
• Do not install the unit near a source of heat,
steam, or flammable gas.
• Install the unit near an electric socket or private
circuit.
• Do not install the unit where it will be exposed to
direct sunlight.
• Select a site where the condensed water can
be easily drained out, and where it is easily
connected to outdoor unit.
• Check the machine operation regularly and
reserve the necessary spaces as shown in the
picture.
• Select a place where the filter can be easily taken
out.
minimum space to be
reserved (mm) showing in
the picture
Mounting plate
Condensed water drain pipe
Sleeve
Insulating covering
Electrical cable
Water drain pipe
Outdoor Unit
• Do not install the outdoor unit near sources of
heat, steam or flammable gas.
• Do not install the unit in too windy or dusty places.
• Do not install the unit where people often pass.
Select a place where the air discharge and
operating sound will not disturb the neighbours.
• Avoid installing the unit where it will be exposed
to direct sunlight (other wise use a protection, if
necessary, that should not interfere with the air
flow).
• Reserve the spaces as shown in the picture for
the air to circulate freely.
• Install the outdoor unit in a safe and solid place.
• If the outdoor unit is subject to vibration, place
rubber gaskets onto the feet of the unit.
minimum space to be
reserved (mm) showing in
the picture
To Next Page
Loading...
