24
ow to use washer
H
• If the washer encounters a fault during
operation, the associated fault will be
displayed.
“ ” : Water pressure sensing error
“ ” : Problem of overfilling water
“ ” : Door is not closed
“ ” : Over load in motor
“ ” : Water inlet trouble
“ ” : Drainage trouble
“ ” : Unbalanced load
“ ” : Water temperature trouble
“ ” : Dry heater or thermostat trouble.
If these error letters are displayed, please refer to
the troubleshooting page31 and follow the guide.
• When Child lock is selected, the
“ ” lamp is on.
• After the end of dry, “ ” is displayed.
• When time delay is selected, it shows the
remaining times to finish the selected
program.
• When washing cycle is completed, “ ”
is displayed on the “Multi display”.
• During washing cycle, the remaining
washing time is displayed.
• Recommended program by manufacturer.
- Refresh : around 20 minutes
- Baby Care :
around 3 hours and 02 minutes
- Allergy Care :
around 2 hours and 20 minutes
- Cotton : around 2 hours and 08 minutes
- Synthetic :
around 1 hour and 33 minutes
- Cotton Quick :
around 1 hour and 06 minutes
- Duvet : around 1 hour and 23 minutes
- Hand Wash/Wool :
around 1 hour and 13 minutes
- Quick30 : around 30 minutes
• The washing time may vary by the amount
of laundry, water pressure, water
temperature and other washing conditions.
• If an unbalanced load is detected or if the
suds removing program operates, the wash
time may be extended.
(Max. increasing time is 45 minutes.)
Display
1. Special function display
3. Completion of washing
4. Time left
2. Self diagnose display
To Next Page
Loading...
