To Next Page
A
Anthony WoodSep 9, 2025
What to do if LG WDV9142 RP shows FE OVERFLOW ERROR?
- KKimberly JohnsonSep 9, 2025
If your LG Washer/Dryer displays an 'FE OVERFLOW ERROR', immediately close the water tap and unplug the power plug. Call for service.
What to do if LG WDV9142 RP shows FE OVERFLOW ERROR?
If your LG Washer/Dryer displays an 'FE OVERFLOW ERROR', immediately close the water tap and unplug the power plug. Call for service.
Why is the drying performance too low on my LG Washer/Dryer?
If the drying performance of your LG Washer/Dryer is too low or bad, ensure the water supply tap is open and that water is properly supplied. Check that the drain filter is not clogged, and avoid overloading the appliance by checking the load capacity for the selected cycle, adding a time dry cycle if needed. Also, select the highest spin speed allowed for the wash cycle.
Why my LG WDV9142 RP Washer/Dryer is not connecting to Wi-Fi?
If your LG home appliance and smartphone are not connected to the Wi-Fi network, and you're sure that the password for the Wi-Fi is correct, find the Wi-Fi network connected to your smartphone and remove it, then register your appliance on LG SmartThinQ. Turn off the Mobile data of your smartphone and register the appliance using the Wi-Fi network. Ensure that the wireless network name (SSID) should be a combination of English letters and numbers (without special characters). Only a 2.4 GHz router frequency is supported, so set the wireless router to 2.4 GHz and connect the appliance to the wireless router.
Why does my LG WDV9142 RP show a UE UNBALANCE ERROR?
The UE UNBALANCE ERROR on your LG Washer/Dryer typically means the laundry load is unbalanced. This can happen if the laundry is too wet at the end of the cycle or if the load is too small. If the laundry is too wet, rearrange it to allow proper spinning. Close the door and press the Start/Pause button. If the load is too small, add one or two similar items or smaller articles of laundry to help balance the load. Then, close the door and press the Start/Pause button. Please note that the door must be locked before spin can be achieved, and it may take a few moments before the appliance begins to spin.
What to do if my LG Washer/Dryer displays a 1E INLET ERROR?
If your LG Washer/Dryer displays a 1E INLET ERROR, it indicates a water supply issue. First, check another tap in the house to ensure the water supply is adequate. Make sure the water supply tap is completely open. Inspect the water supply hoses for kinks and straighten them or reinstall the water inlet hose. Finally, check and clean the filter of the inlet hose, and if water leakage occurs in the aqua stop supply hose, replace it.
How to fix OE WATER OUTLET ERROR on LG WDV9142 RP?
If your LG Washer/Dryer shows an OE WATER OUTLET ERROR, it means there's a problem with the water draining. Check the drain hose for kinks or clogs and clean and straighten it. Also, check and clean the drain filter.
Why am I seeing staining on clothes after using my LG WDV9142 RP?
If you notice staining on your clothes after washing in your LG Washer/Dryer, it could be because bleach or softener is dispensed too soon due to an overfilled dispenser compartment. Always use the dispensers to ensure that laundry products are properly dispensed at the right time in the cycle. Also, ensure clothes are properly sorted, washing dark colors separately from light colors and whites to prevent discoloration.
Why does my LG Washer/Dryer smell musty?
If you notice a musty or mildewy odor in your LG Washer/Dryer, run the Tub Clean function regularly. Ensure the drain hose is properly installed to prevent siphoning, and clean the detergent dispenser drawer, especially the top and bottom of the drawer’s opening.
Why is my LG Washer/Dryer making a rattling noise?
If your LG Washer/Dryer is making a rattling and clanking noise, stop the appliance and check the drum for foreign objects such as keys, coins, or safety pins. If the noise continues after restarting the appliance, call for service.
Why is my LG WDV9142 RP appliance not filling properly?
If your LG Washer/Dryer isn't filling properly, ensure that the inlet filters on the fill valves are not clogged and that the inlet hoses are not kinked or clogged. Make sure both hot and cold water taps are turned on all the way, and check the inlet hose connections to ensure they are not reversed.
General| Type | Washer/Dryer Combo |
|---|---|
| Steam Function | Yes |
| Washer Type | Front Load |
| Wash Cycles | 14 |
| Wi-Fi Enabled | Yes |
| SmartThinQ Compatible | Yes |
| Dryer Type | Condenser |
