52
7) Water does not drain.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
4. Check whether the drain hose is
blocked by foreign objects. It may
happen in case of the hose is a little
kinked.
PV Case
(for Non-Pump Model only)
1. Check whether the PV asm is
blocked by foreign objects.
Drain Motor
(For Non-Pump Model onl
y)
1. Check resistance of the drain
motor if it can not pull the PV link.
Blocked.
Blocked.
Resistance is
normal.
Blocked hose.
Drain motor coil is
open.
Contact defect in
connection parts
or defect of the
controller.
Remove the objects and
reinstall so that it can’t
be kinked.
Separate the drain motor
from the PV link,
disassemble PV cover
and then remove the
foreign objects within
PV case.
Check the washer works
normally after repair
and reassembling them.
(PV link & drain motor
lever should be
assembled accuratel.)
Change the drain motor
Check the washer
works normally after
reassembling.
(PV link & drain motor
lever should be
assembled accurately.)
Change the controller if
there is no defects in the
connection parts.
To Next Page
Loading...
Need help?
General
