54
10) Spin extraction is not proceeded.
Where, what & how to check? Result of Check Possible Cause How to repair & settle
Motor
1. In the case that the wash motor
does not spin during spin extraction;
1) Check there is motor working
sound,or
2) If there is no motor-working
sound;
Check frequency of the
Ball Pressure Sensor, under
no load, or
Is placed the magnetic in
Lid-B.
Check resistance of the motor.
Drain Motor/Clutch
1. In the case the motor rotates but the
inner tub does not rotates;
1) Check resistance of the drain
motor if the drain motor doesn’t
work,or
2) Check gap between the PV link
and the brake lever if the inner
tub does not rotates while the
drain motor works.
There is motor
working sound.
Less than
26.3
The lid is open.
Defect of magnetic in
LID-B
Contact defect
of the Ball
Pressure Sensor
Resistance is
normal
The clearance is
less than 2.0mm
or more then
3.5mm
The gap is
normal .
(2.0~3.5mm)
Defect of the
capacitor or
Mechanically
locked.
Defect of the
Ball Pressure
Sensor.
Mistake in use.
Coil is open.
Coil is open.
Defect of
connection part
or defect of the
controller.
Assembling defect
of the drain motor
or the clutch
Defect of the
clutch.
Change the capacitor
after checking defect of
capacitor.
check whether the
washing clutch or the
washing tub is blocked
if the motor rotates after
removing the V-belt.
Check whether the
motor is locked if the
motor does not rotates
even though the V-belt
being removed.
Change the Ball
Pressure Sensor.
Explain” The lid is close
during operation”
Change the Lid-B
Change the Ball
Pressure Sensor.
Change the motor.
Change the drain motor.
Change the controller
after checking
connection parts.
Reassemble the drain
motor or the clutch to
keep the clearance.
Change the clutch.
To Next Page
Loading...
Need help?
General
