To Next PageTo Next PageHow to stop my LG WM1455HPA from making loud banging noises when filling?
The loud banging noises occurring while your LG washer fills with water are related to your home's plumbing. To resolve this, install a water hammer arrestor.
Why does my LG WM1455HPA show an IE INLET ERROR?
The 'IE INLET ERROR' on your LG washer indicates a water supply issue. Here's what you should check: 1. Ensure that the water supply faucets are fully open. 2. Inspect the water inlet hoses for any kinks, pinches, or crushing, especially behind or under the washer. 3. If the issue persists, the water inlet filters may be clogged. Clean the inlet filters. 4. Verify that the household water pressure is adequate by checking another faucet. If the pressure is low, or flow is restricted, disconnect the water inlet hoses and flush them to remove any dirt. If the flow remains low, contact a plumber to repair the water supply lines. 5. Avoid using leak-limiting hoses, as they can falsely trigger and prevent the washer from filling.
How to disable CL CONTROL LOCK FUNCTION on LG WM1455HPA Washer?
The CL CONTROL LOCK FUNCTION on your LG washer is on to prevent changes to cycles or operation. Turn off the Control Lock function in the control panel.
Why is my LG WM1455HPA not filling properly?
If your LG washer isn't filling properly, check that the inlet filters on the fill valves are not clogged. Also, inspect the inlet hoses to ensure they are not kinked or clogged.
Why is detergent not dispensing correctly in my LG Washer?
If detergent isn't dispensing correctly in your LG washer, it could be due to clogged detergent compartments from incorrect filling. Make sure detergent and additives are put into the correct dispenser compartments. Also, ensure you're not using too much detergent and that both hot and cold water faucets are fully turned on for sufficient water supply.
What to do if my LG WM1455HPA will not operate?
If your LG washer won't operate, first check if the control panel has powered off due to inactivity; if so, press the Power button. Ensure the washer is plugged securely into an electrical outlet and that the water supply is turned on fully at both hot and cold faucets. Also, verify the cycle is set correctly, the door is closed, and the Start/Pause button is pressed.
What to do if water in my LG WM1455HPA Washer doesn't drain or drains slowly?
If the water in your LG washer isn't draining properly or is draining slowly, check the drain hose for clogs or kinks and ensure it's free. Also, make sure the end of the drain hose is not more than 96 inches (2.4 m) above the bottom of the washer; if it is, lower it.
Why is my LG WM1455HPA Washer leaking water?
If your LG washer is leaking water, inspect the hoses and connectors for any leaks, cracks, or splits. If the house drain pipes are clogged, contact a plumber. Ensure the drain hose is properly inserted into the drain connector and is secured to prevent it from coming out during the drain cycle. Also, reduce the amount of detergent used, especially for small or lightly soiled loads, as excessive sudsing can cause leaks.
How to fix UE UNBALANCE ERROR on LG WM1455HPA Washer?
If you're getting a UE UNBALANCE ERROR on your LG washer, it means the load is unbalanced. Try these solutions: if the load is too small, add additional items to help balance it. If you're washing heavy items with lighter ones, separate them into similar weight categories. If the items are tangled, manually redistribute them in the drum.
How to fix an LG Washer that will not turn on?
If your LG washer won't turn on, start by ensuring the power cord is properly plugged into a grounded outlet. Also, check your house fuse or circuit breaker; reset the breaker or replace the fuse if necessary.
General
