To Next PageTo Next PageWhat to do if the LG WM2240 is leaking water around?
If your LG Washer is leaking water, check the faucets and water lines for loose connections. If you find loosely connected water lines, connect them properly. Also, inspect the drain pipe or drain hose for any clogs and clear them. If needed, consider contacting a plumber for assistance.
How to fix LG Washer if power is not turned on?
If your LG Washer isn't turning on, ensure the power cord is correctly plugged into a grounded outlet. Check your home's fuse box for blown fuses or tripped circuit breakers and reset them or replace the fuse. If a circuit overload is the issue, consult a qualified electrician to correct it.
What to do if the LG WM2240 drains slowly or not at all?
If your LG Washer is draining slowly or not at all, lower the drain hose to within 3 feet below the end of the elbow bracket. Ensure the drain hose rests on a smooth surface to prevent bending. Thaw frozen drain hoses with warm water if necessary. Open the drain pump plug cap and remove any accumulated dirt.
What to do if the LG WM2240 door does not open?
If the door of your LG Washer won't open after the cycle pauses or finishes, it could be due to high temperature or the tub being full of water. The washing machine has a safety lock to prevent burning. Wait until the door lock icon disappears from the display. Alternatively, wait for the wash cycle to finish completely or turn the knob to Drain & Spin to remove the water and open the door.
What to do if the LG Washer tub does not rotate?
If your LG Washer's tub does not rotate, close and secure the door properly. If the issue persists, unplug the power and contact your nearest LG service center.
Why does LG Washer tub not rotate?
If your LG Washer's tub does not rotate, rearrange the load size and restart the washing machine. If the load size is big, the tub may not rotate due to an overheated motor. Allow the washing machine to stand for a while and restart the cycle. If the same error message appears, unplug the power cord and contact your nearest LG service center.
Why does my LG WM2240 Washer have excessive suds or failure of rinse?
If your LG Washer is producing excessive suds or failing to rinse properly, it might be due to using too much detergent or the soil level being higher than the load size. To resolve this, use the recommended amount of detergent for the load. Reduce the detergent quantity if the contamination level is low. Ensure you're using detergent with the HE (High-Efficiency) logo.
How to fix LG Washer when clothing is gathered on one side?
If items of clothing have gathered on one side of the tub in your LG Washer, rearrange the items to help balance the load. Stuffed animals or mats can cause imbalance during spinning, leading to drainage issues. Rearrange knitwear to balance the load and try draining again. Put one blanket at a time.
Why is water not supplied to LG WM2240 or water pressure is low?
If the water is not supplied or the water pressure is low in your LG Washer, first, turn on the faucets completely. If a faucet is frozen, thaw it with warm water. Clean the inlet filter if it's clogged. Connect the water line properly with the cold water inlet. Ensure the water lines are not pinched or bent.
Why is the wash cycle time longer than usual on my LG WM2240?
If the wash cycle time is longer than usual in your LG Washer, this is normal. The washing machine automatically adjusts the cycle time for the amount of laundry, water pressure, water temperature, and other operating conditions.
Emphasizes reading all instructions and following basic precautions to prevent hazards.
Covers grounding, installation safety, and safe use, care, cleaning, and disposal procedures.
Outlines the sequence of steps for installing the washing machine correctly.
Guides on choosing a location, space requirements, and connecting water/drain lines.
Covers machine leveling, power cord connection, grounding, and performing a test run.
General
