LG WM2277H Series - Error Code IE; Error Code DE; Error Code UE; Error Code dE

TROUBLESHOOTING GUIDE
Problem
Possible Cause
' Water supply is rK>t adequate in
area.
' Water supply taps are not
completely open.
' Water inlet hose is bent.
' The filter of the inlet hose clogged.
■ Drain hose is bent
or clogged.
■ The drain filter is clogged.
■ Load is too small.
• Load is out of balance.
> The appliartce has an imbalance
detection and correction system. It
individual heavy articles are loaded
(bath mat, bath robe, etc.) and the
imbalance is too great, after several
attempts to restart the spin cycle the
machine will stop and the error code
will be displayed.
' Is the door opened or rK>t
completely closed?
Solution
Check another tap in the house.
Fully c^n tap.
Straighten hose.
Check the filter of the inlet hose.
Clean arKj straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door completely.
« If it is not released, call for service.
Unplug the power plug and call for service.
' The water overfills due to the
faulty water valve.
' The water level sensor
malfunction.
' Overload in motor.
' The washer experienced a power
failure.
Close the water tap.
Unplug the power pHug.
Call for service.
Restart the cycle after 30 minutes. If LE is
not released, call for service.
Restart the cycle.
22