Installation Instructions
20
lacing and Leveling
P
Check that the machine is level and securely installed not to move.
Open the lid and look from above to see if it is
same as shown beside.
2
Please ensure that transit restraint has been removed before operating your machine.
more than 4”
more
than
1”
more than 1”
Place the machine on a flat and firm surface which allows proper clearance.
Concreate flooring is best. Washer should not be installed
on rugs or exposed to the weather.
We suggest a minimum clearance of 1” from right and left
sides and 4” from rear wall.
1
Caution
If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or “ ” error can happen to it.
It must be placed on a firm and level floor to prevent spin failure.
Top view of the machine
Washer with Casters
An insecure installation may cause walking during spin cycles because the washer has casters for
convenience to move.
To protect it from walking, place the leg stoppers, which are provided as a accessory, under the
two front legs of washer as shown in the figure.
Caution
If the power is supplied from a cord extension set or generator, the cord extension set or
electrical portable outlet device should be positioned so that it is not exposed to splashing or
ingress of moisture.
To Next Page
Loading...
