LG WT19WSBP - Page 19

19
Copyright © 2017 LG Electronics Inc. All rights reserved.
Only
training and service purposes.
Option Program
Soak
• Soak can be selected to wash heavily soiled
laundry by soaking in water for some time to
remove dirt and grime.
• Press the Wash button to until the
and
light turn on simultaneously.
Soil Level
• This button allows you to select the strength
of the wash action.
• There are 2 Levels for Soil Level selection :
Heavy and Light. This can be selected for any
programme.
• If you do not select the Soil Level, it will be in
the normal state with the light turned off.
• Adjutment can be made while washing.
Water Level
• Press the Water Level button to adjust water
level.
• It can be changed during operation.
• This machine detects the quantity of laundry
automatically, then sets Water Level. It may
be necessary to increase the water level
manually when washing bulky light weight
clothes.
• When you select a wash programme, the
Water Level will be shown on the control
panel.
• When Water Level is automatically detected, it
may differ depending on the quantity of
laundry even though the same Water Level is
indicated on the control panel.
• Water level can be changed when operation is
paused.
Wash
• Press the Wash button to change laundry
time.
• Adjusting the wash level setting will modify the
cycle times and/or wash actions. Press the
Wash button until the desired wash level is
selected.
Rinse
• Press the Rinse button to change the number
of rinses.
Spin
• Press the Spin button to change spin
strength.
• Press Start/Pause button to indicate
remaining time.
Beeper
• If you want to use the washing machine
without the alarm signal sounds, press the
Beeper button allow you to select: High →
Low → Off → High respectively.
• Default setting is High.
Delay
• You can set a time delay so that the washing
machine will start automatically and finish after
a specified time interval.
1
Press the Power button.
2
Select a washing programme.
3
Press the Delay button to set the required
Delay time.
4
Press the Start/Pause button.
NOTE
• The delay time is the time to the end of the
programme, not the start. The actual running
time may vary due to water temperature, wash
load and other factors.
• Reservation can be made up to 18 hours by
1-hour interval up to 3 - 12 hours and 2-hour
interval for 12 - 18 hours. The Delay cannot
be set for less than 3 hours.
• To cancel the Delay function, press Delay
button repeatedly until the reservation is
canceled or press the Power button to turn off
and on power.