Presetting the start time, DELAY WASH
You can set the desired start time.
1
Turn the cycle selector knob to the desired cycle.
2
Press the desired option to use the other options.
3
Press repeatedly to select the desired start time.
-
light will turn on.
- The set start time appears on the display panel.
- Each press of the button increases the delay time by
one hour, up to 19 hours.
4
Press .
Setting customized wash cycle, CUSTOM
PROGRAM
*PGM SAVE
CUSTOM PROGRAM allows you to store a customized
wash cycle for future use. It allows you to save favorite
temperature, spin speed, soil level, and other options for a
cycle, and then recall them at the touch of a button.
1
Press the POWER button to turn on the washer.
2
Turn the cycle selector knob to select the desired cycle.
-
light will turn on.
3
Press the cycle modifier button to change the desired
setting.
4
Press the cycle option button to add the desired options.
5
Press and hold the CUSTOM PROGRAM button for 3
seconds.
To recall a custom program:
1
Press the POWER button to turn on the washer.
2
Press the CUSTOM PROGRAM button. The stored
settings will be displayed.
3
Press the START/PAUSE button to start the cycle. (If
you press any other button, CUSTOM PROGRAM is
automatically deselected and indicator light off.)
NOTE
You may only save one custom program at a time.
y
Pressing and holding the CUSTOM PROGRAM button
will overwrite any previously saved custom program.
Setting options during cycle
You can add the desired options during the wash cycle.
Button lock feature, SIGNAL OFF-LOW-
HIGH
*CHILD LOCK
You can lock the washing machine to prevent children or
others from changing the cycle settings by pressing the
buttons during the cycle.
To enable child lock
Press and hold for 3 seconds during the wash cycle.
- When the CHILD LOCK is enabled, a
N
message and the
remaining wash time are displayed, in turn, on the display
panel of the washing machine.
To disable child lock
(When the CHILD LOCK is activated.)
Press and hold
for 3 seconds during the wash cycle.
NOTE
Once the controls are locked, they must be manually
y
unlocked to restore operation.
Setting water plus, WATER PLUS
Select this option to add extra water to the wash and rinse
cycles for superior results, especially with large or bulky
items.
Press and hold the
button for 3 seconds to activate or
deactivate WATER PLUS.
If you chose the WATER PLUS option, you can hear the
beeper sound. There is no sound in case of SIGNAL OFF.
1
Press the button during wash or rinse cycle.(It is not
available in spin cycle)
2
Press and hold the EXTRA RINSE.
3
Press the button to start the cycle.
4
If you want to use additional water, repeat steps 1
through 3.
NOTE
If the machine reaches its maximum water level, the
y
WATER PLUS button will have no effect.
You cannot select the WATER PLUS option in the TUB
y
CLEAN, and BULKY/BEDDING cycle.
To Next Page
Loading...
