23OPERATION
ENGLISH
Time and Status Display
a Estimated Time Remaining
• When a cycle is selected, the default time for that cycle is displayed. This time will change as modifiers
or options are selected.
• If the display shows
--, then the time will be displayed after the load sensing has detected the load
size.
• The time shown is only an estimate. This time is based on normal operating conditions. Several
external factors (load size, room temperature, incoming water temperature, etc.) can affect the actual
time.
• Once the Start/Pause button is pressed, the washer will measure the size of the load. The estimated
time may change once the load size has been measured.
• If the Delay Wash function is set, the remaining delay time counts down until the cycle begins.
b Cycle Status Indicators
• These LEDs will blink when a cycle is selected to indicate which stages will run.
• When a cycle is running, the LED for the active stage will blink, and the LEDs for the remaining stages
will remain steady. Once a stage is complete, the LED will turn off. If a cycle is paused, the active stage
LED will stop blinking.
c Door Lock Indicator
• This indicator lights up when the cycle starts and the door is locked.
• The indicator light stays on until the cycle is paused, stopped or has finished.
d Control Lock Indicator
• This indicator lights up when the control panel is locked.
•
CL and the remaining wash time are displayed, in turn, on the time remaining display.
• When this function is set, all controls are disabled except for the Power button.
e Add Garments Indicator
• Laundry may only be added to the tub at the proper time in the wash cycle. When this indicator lights
up, it is safe to pause the cycle and add more items to the tub.
• If garments are added when this indicator turns off, the washer will not adjust for these items which
could result in poor performance and/or fabric damage.
To Next Page
Loading...
Need help?
General
