23OPERATION
ENGLISH
Time and Status Display
1
4
2 3
Door Lock Indicator
The Door Lock indicator will light up once a cycle
has started. The indicator light will stay on until
the cycle is paused, stopped or has finished.
Wi-Fi Connect Indicator
The indicator blinks during product registration
and Wi-Fi setup and illuminates when the
appliance is connected to a home Wi-Fi network.
Cycle Status Indicator
These LEDs illuminate when a cycle is selected
to indicate which stages are included. When a
cycle is running, the LED for the active stage
blinks, and the LEDs for the remaining stages
remain steady.
Once a stage is complete, the LED turns off. If
a cycle is paused, the active stage LED stops
blinking.
Estimated Time Remaining
When a cycle is selected, the default time for
that cycle is displayed. This time will change
as modifiers or options are selected. Once the
Start/Pause button is pressed, the washer will
measure the size of the load. The estimated
time may change once the load size has been
measured. If Delay Wash is set, the remaining
delay time counts down until the cycle begins.
NOTE
• The time shown is only an estimate. This time is
based on normal operating conditions. Several
external factors (load size, room temperature,
incoming water temperature,etc.) can affect the
actual time.
1
2
3
4
To Next Page
Loading...
Need help?
General
