32
4) Water doesn’t come into the wash tub.
Result of Check Possible Cause How to repair and settle
Inlet Valve
1. If water doesn’t come though the
inlet valve works (electric sound
occurs).
1) Check whether water is off.
2) Check whether taps are turned on.
3) HOT and COLD taps are connected
backwards.
4) Incorrect water temperature
selected.
5) If there are no problems in the
above, check the inlet valve filters
after disconnecting the water supply
hoses.
6) If there are no problems in the
above, a diaphragm hole in the valve
is blocked by foreign substance or
the plunger in it is locked.
2. If the inlet valve doesn’t work (there
is no electric sound) during filling
cycle.
1) Check for a loose or bad
connection.
2) Check resistance of the inlet valve.
Water off.
Don’t turn on.
Connected
opposite.
Selected
opposite.
Filters blocked
by foreign
substance.
A connector is
taken off.
Water off.
Mistake of use.
Wrong installation.
Mistake of use.
Don’t clean.
Defect of the
inlet valve.
Defect of contact.
Coil is open.
Explain.
Turn on the tap.
Correct their locations
and turn on the tap.
Explain how to use.
Clean them by brush
and explain cleaning
regularly them.
Change the inlet valve.
Reconnect it or remove
the causes to make poor
connection.
Change the inlet valve.
Where, what, and how to check? Result of Check Possible Cause How to repair and settle
Drain Motor
1. Operate washer setting spin only,
then press the START/PAUSE button
when the wash motor starts to work
and then press the START/PAUSE
button again in order for the drain
motor to work intermittently.
Contr
oller
1. If line voltage and the drain motor
have no defects, a defect of the
controller is highly possible.
Reset happens
after the dr ain
motor works.
Defect of the drain
motor (A noise
generated when the
internal relay
works.)
Change the drain motor.
Change the controller.
3) Reset during operation
Where, what, and how to check?
To Next Page
Loading...
