Water tap
Rubber Seal
Water Supply Hose
1
Be sure there is a gasket in both ends of the hose.
Push the water supply hose up so that the rubber gasket
within the hose can adhere completely to the tap.
2
Connect the water supply hose to the tap.
Run a couple of gallons of water through the hoses into the drain or a
bucket to flush any particulate or contaminate.
3
Check water leakage.
After connecting the hose, open the tap to check for
any water leakage.
Connecting Water Supply Hose to the Machine
• Be sure there is a gasket in the end of the hose.
• Connect the hose to the appropriate inlet valve
firmly.
• Turn on the water and check for leaks.
• Always install new hoses with a new washing
machine Do not re-use old hoses.
• Replace the hoses every five years.
Screw Type
2-2. CONNECTING WATER SUPPLY HOSE
6
Before connecting the water supply hose to the water tap, check the hose type, and then choose the
correct instruction here below.
(hot or cold) of the washing machine and tighten it
Gasket
Gasket
• The hot and cold hoses are marked with a red or
blue stripe. Connect them to the appropriate taps.
• The hoses may appear the same, but they are not
physically identical. The hot hose has stronger walls,
a higher temperature rating, and a higher burst
strength. Do not reverse the hoses.
NOTE :
To Next Page
Loading...
