36
7) Water does not drain.
Where, what, and how to check? Result of Check Possible Cause How to repair and settle
4. Check whether the drain hose is
blocked by foreign objects. It may
happen in case of the hose is a little
kinked.
Drain Motor
(For Non-Pump Model only)
1. Check resistance of the drain
motor if it can not pull the P.V. link.
Blocked.
Resistance is
normal.
Blocked hose.
Drain motor coil is
open.
Contact defect in
connection parts
or defect of the
controller.
Remove the objects and
reinstall so that it can’t
be kinked.
Change the drain motor
Check the washer
works normally after
reassembling.
(P.V. link and drain motor
lever should be
assembled accurately.)
Change the controller if
there is no defects in the
connection parts.
To Next Page
Loading...
