39
11) Spining is going on even though the lid is open.
Where, what, and how to check?
Result of Check Possible Cause How to repair and settle
Pressure Sensor
1. Is a magnet placed on the washer?
Yes
No
Reed switch is short
by magnetic on
the washer.
Reed Switch.
Keep magnet away from
the washer.
Change the controller.
12) Spin basket doesn’t reach to full speed (normal rpm)
Result of Check Possible Cause How to repair and settle
Main voltage
1. Check voltage at the power outlet
where the washer is plugged into.
Starting Capacitor
1. Check the capacitance of the
starting capacitor.
Clutch Assembling
1. Check the clearance between the
P.V. link and the brake lever and
clearance between the clutch lever
and the adjustment bolt.
Blocked by foreign objects
1. Check whether the P.V. assembly, the
drain pump and the drain hose are
blocked by foreign objects so that it
makes water-splashing noise in the
tub.
Less than
85% of rating
Lack of
capacitance
The clearance is
less than 2.0
mm
or more than 3.5
mm
Bolt clearance is
out of range
1.9
0.1mm
Too low voltage
Defect of
capacitor
Defect of the
clutch.
Explain the cause and
recommend using a
transformer if
necessary.
Change the capacitor.
Adjust P.V. lever bolt and
paint it red.
Reassemble the dr ain
motor or the clutch.
Adjust the bolt
clearance.
Remove the foreign
objects.
Where, what, and how to check?
To Next Page
Loading...
