Installing device drivers
If you are using Windows 7 and 8, you'll need to install device drivers. After con-
necting the LI-830 and LI-850 to your computer with the USB cable, follow these
steps:
1
Download the drivers and unzip the file.
Drivers are available at licor.com/env/support/LI-850/software.html or directly at
licor.com/documents/pamrygkdwsl8c61wj6y815gnf4tukh3t
2
Press the Windows key ( ), type Device Manager, and press Enter to open your device
manager.
3
Under Other Devices, select the LI-830/LI-850.
4
Right-click LI-830/LI-850 and select Update Driver Software.
5
Browse and select the folder with the driver files.
6
Click Next to finish installing the drivers.
When they are installed, you should see LI-COR 8x0 under Ports (COM & LPT).
Storing the gas analyzer
When you are done using the gas analyzer, follow these practices to be sure that it is
ready to use the next time you need it. The instrument can be stored in non-con-
densing conditions. If the instrument is stored in high humidity or moderate humid-
ity for a long time while powered off, some optical components may temporarily
become saturated with humidity. If this occurs, the instrument may need to run for
several days before readings return to normal. When storing the instrument.
l
Install the covers over the air inlet and outlet. This will keep dust, bugs, and
other contaminants out of the optical cell.
l
Disconnect the power supply and power wires.
l
If possible, store the instrument in an air conditioned environment.
Section 2. Connecting with the analyzer
2-5Installing device drivers
To Next Page
Loading...
Need help?
General
