Appendix B. Specifications
Serial cable pin assignments
The image below shows the pin assignments for the 9-pin RS-232 serial connector.
Serial communication parameters
The LI-830 and LI-850 can communicate through a RS-232 serial port on the front
of the instrument. You may need to set the communication parameters on your com-
puter or your terminal emulator program. The RS-232 port is configured as Data Ter-
minal Equipment (DTE) with no hardware handshaking. It is bi-directional,
meaning information can be transferred both into and out of the instrument. The
port is configured as follows:
l
Baud Rate: 9600 bps
l
Data Bits: 8
l
Parity: None
l
Stop Bits: 1
l
Flow Control: None
B-4 Using the LI-830 and LI-850 Gas Analyzers
To Next Page
Loading...
Need help?
General
