To Next Page
A
Anita JohnsonJul 28, 2025
How to troubleshoot a Liberty Pumps Water Pump that will not run?
- JJose SmithJul 28, 2025
If your Liberty Pumps Water Pump isn't running, start by checking the fuse or breaker. Replace the fuse with the correct size or reset the breaker. Also, verify the voltage; if it's below 108V, inspect the wiring size and remove any extension cords, or use a heavier gauge one. Other potential causes include worn motor brushes (replace them), a blocked impeller (remove the blockage by removing the 4 screws that retain the impeller plate or by removing the cap located at the back of the unit and turning the shaft with a flat screwdriver), or a defective motor or switch (consult factory to replace).
General
