S
Samuel ShepherdJul 25, 2025
How to reset Liberty Pumps Camera Accessories charger?
- AAlyssa NelsonJul 26, 2025
To reset the charger, unplug it from the 120V outlet for 10 seconds, and then plug it back in.
To Next PageTo Next PageHow to reset Liberty Pumps Camera Accessories charger?
To reset the charger, unplug it from the 120V outlet for 10 seconds, and then plug it back in.
Why is the yellow LED light flashing on and off on my Liberty Pumps Camera Accessories?
The yellow LED light flashes when the battery has been left in a state of discharge for an extended period. The charger will attempt to charge the battery, and the normal duration of this stage ranges from 18 minutes to 27 hours. It may require 27 hours to determine if the battery will accept a charge.
What does it mean when the green LED light is on on Liberty Pumps Camera Accessories?
A green LED light indicates that the battery is charged and ready for use, and that charging has stopped.
How long to recharge a 24M battery in 'dead battery condition' for Liberty Pumps Camera Accessories?
It takes approximately 75 hours to recharge a 24M battery.
How long does it take to recharge a 27M battery in 'dead battery condition' for Liberty Pumps Camera Accessories?
It takes approximately 100+ hours to fully recharge a 27M battery in a 'dead battery condition'.
General| Model | 441 |
|---|---|
| Category | Water Pump |
| Horsepower | 1/3 HP |
| Voltage | 115V |
| Weight | 12 lbs |
| Cord Length | 10 feet |
| Motor Housing Material | Thermoplastic |
| Float Switch Included | Yes |
| Warranty | 3 years |
| Type | Sump Pump |
| Discharge Size | 1-1/2 inch |
| Phase | Single Phase |
Critical safety warnings and guidelines for operating and installing the system.
Overview of the Model 441 system's purpose, limitations, and included parts.
Details the individual parts that make up the battery back-up pump system.
Details various recommended methods for assembling and installing the back-up pump system.
Lists required tools, materials, and essential preparation steps for installation.
Step-by-step guide for assembling the back-up pump, including float adjustment.
Safety and operating instructions for the 12V battery charger.
Specifications, operation, and connection for the 1.5A charger.
Specifications, operation, and connection for the 10A charger.
Procedures for operating, starting, and testing the installed back-up pump system.
Guidelines for monthly maintenance of the pump, charger, and battery.
Solutions for common problems with the pump and chargers.
