Troubleshooting Guide
On-Ear - Name not listed correctly in
Bluetooth
Follow this procedure if your On-Ear customized name is not listed correctly in the Bluetooth list
on your iPhone:
1. Use Libratone App to re-name your On-Ear
2. Switch OFF your On-Ear
3. Go to "Settings" and "Bluetooth" on your iPhone
4. Locate your On-Ear (Libratone Q ADAPT O....) in "My Devices" and press the "i" on the right hand
side
5. Press "Forget This Device"
6. Press "Forget This Device" again
7. Switch ON your On-Ear
8. Activate paring mode by long pressing the setup button on the right side of you On-Ear until a
side-to-side signal appears in the Touch Interface
9. Go to "Settings" and "Bluetooth" on your iPhone
10. Now you can press your re-named On-Ear in "Other Devices"
On-Ear - Ears squeezed
At Libratone we do our utmost to find the size that fit most customers.
However - sometimes ears are squeezed during use of our Q Adapt On-Ear.
Try mounting your headphones stretched over some books over night.
That may remove some pressure on your ears.
Don't stretch you earphones to much. You can always add an extra book the following night :)
On-Ear - Volume Control
To turn the volume up, slide your finger around the Nightingale in a clockwise motion.
To Next Page
Need help?
General
