What to do if Liebert UPS has green LED off, red LED on, and continuous beeps?
If the green LED is off, the red LED is lit, and you hear continuous beeps from your Liebert UPS, it could be due to an output short circuit or an overload exceeding 120%. In the first case, remove all of the equipment. In the second case, reduce the load on the UPS.
Why does my Liebert UPS beep with green LED on and red LED blinking?
If the green LED lights up, the red LED blinks, and you hear one beep every half-second from your Liebert UPS, it means the power demand from the connected equipment is too high. To resolve this, remove some equipment until the UPS stops beeping.
How to troubleshoot no input voltage on Liebert PowerSure Personal XT 450?
If your Liebert UPS has no input voltage, first, check the building wall outlet and mains cable by connecting another device with cable to this wall outlet. If the fuse has melted, replace it with a fuse of the same rating.
Identifies and illustrates the main parts of the UPS unit, including front and back views.
Disclaims responsibility for UPS use in critical life support applications.
Provides information about Liebert's history and product offerings in protection systems.
Identifies and illustrates the main parts of the UPS unit, including front and back views.
Disclaims responsibility for UPS use in critical life support applications.
Provides information about Liebert's history and product offerings in protection systems.
General| Power Rating | 450 VA |
|---|---|
| Form Factor | Tower |
| Humidity | 0% to 95% non-condensing |
| Output Frequency | 50/60 Hz |
| Battery Type | Sealed Lead Acid |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Wattage | 280 Watts |
| Output Voltage | 230 VAC |
| Input Voltage | 230 VAC |
| Waveform Type | Stepped approximation to a sinewave |
To Next Page