Life Fitness 9500L User Manual

Life Fitness Model 9500L Cross-Trainer
How To...Remove and Replace the 4”, and 14” Linkage Assemblies
Tools Required: Torx Key or Standard Screwdriver, Socket Set, Wrench Set, Hex Key Set Kit # GK53-00002-0021
IMPORTANT!
PLEASE READ THROUGH THESE INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL THIS KIT.
FAILURE TO FOLLOW THE STEPS IN PROPER SEQUENCE COULD CAUSE DAMAGE TO THE EQUIPMENT.
1 Washer Qty: 4
0017-00104-0402
2 Brass Washer Qty: 4
0017-00006-0226
3 Delrin Spacer Qty: 4
OK53-01384-0000
4 Metal Washer Qty: 4
0017-00104-0369
5 Shouldered Sleeve Qty: 4
0K53-01346-0017
6 3/4” Sleeve Qty: 2
OK53-01342-0000
7 Bolt w/Locktite Qty: 2
0017-00101-1610
8 External Lock Washer Qty: 4
0017-00104-0302
9 Jam Nut Qty: 4
0017-00103-0273
10 Bolt Qty: 2
0017-00101-1606
11 Bolt Qty: 2
0017-00101-1608
WARNING: FAILURE TO OBSERVE SAFETY PROCEDURES WHEN SERVICING THIS UNIT
COULD RESULT IN INJURY FROM ELECTRICAL SHOCK
5
10
1
8 9
4
2
3
7
6
11

Life Fitness 9500L Specifications

General

Brand	Life Fitness
Model	9500L
Category	Fitness Equipment
Language	English

Summary

Installation Instructions

Preparation and Safety

Turn off power, unplug unit, and read all instructions before installation. Check for safety warnings.

Removing Hood Shroud Panel

Locate and depress push snap rivets to release the hood shroud panel, then remove eight screws.

Removing Linkage Assemblies

Pivot pedal lever, remove nuts, washers, and bolts from linkage points, and discard old sleeves.

Replacing Linkage Assemblies

Install new linkage assemblies, spacers, washers, and bolts, ensuring proper seating and tightening.

Final Assembly and Checks

Attach linkage bars, slide bolts through extension arms, and reverse shroud panel installation.